Waijung 2 User Guide

Configuration Parameter

Selectable Option/Value

Description

Mode

Normal -- Continuous

Normal: Initialize & Deinitialize I2C driver every time a I2C block is used.

Continuous: The I2C driver will be initialized only once

I2C driver port

0--1

Select driver port

Clock Frequency (kHz)

100--400

Specify clock speed of selected I2C module configuration.

SDA pin

Select pin for I2C SDA, The available list of pins will be adjusted according to the target family selected in the Target Setup Block

SDA internal pullup

Enable/disable internal pullup

SCL pin

Select pin for I2C SCL, The available list of pins will be adjusted according to the target family selected in the Target Setup Block

SCL internal pullup

Enable/disable internal pullup

Bytes write count

Specify number of bytes to write to I2C in a transaction.

Bytes read count

Specify number of bytes to read from I2C in a transaction.

Enable I2C scan device ESP log message.

Enable this to scan all i2c devices connected and display their slave addresses. To use this, feature a serial monitor is required.

Sample time (sec)

-1 (inherited) or specify

Specify sample time for the block

Port Name

Port Type

Date Type

Description

Slave address

Vector

uint8

Slave device address

Wr(i) (uint8)

Scalar

uint8

Bytes that need to be sent to the above specific slave address

Status

Scalar

uint8

Read or Write byte status. If error = -1 or Ok = 0

Rd (uint8)(i)

Scalar

uint8

Bytes that need to be read by the above specific slave address